GROLAB USERBOT HW01 Manuel D'installation page 27

Send the 'S' command with the op on 'No
line ending', type the desired serial number
(sending digit by digit) and when you reach
the last number send it with the op on 'Both
NL & CR'. Note the serial number should be
composed of 10 numbers and start by the
number '5', for example, '5123456789'.*
To check if everything is correct, send the 'D'
command with the op on 'No line ending'.
You should see something similar to the
following image through the 'Serial Monitor':
A er comple ng all the previous steps,
Arduino is already set up and ready to
communicate with GroNode through the
UserBot shield.
*The serial number '5999999999' is reserved as the default
one and should not be used.
EN
ES
FR
PT
IT
26 2