Dibo JMB-MG Mode D'emploi page 140

E N
T U R N O F F
SCOPE OF APPLICATION
Efficient high pressure cleaning is achieved by following a few guidelines
combined with your own experiences. Each cleaning job is different and
specific, therefore contact DiBO for the best solution in your application sector.
• Using cleaning products (if applicable): the surface to clean should be sprayed
so the product can act during some time (do not let it dry!) before cleaning
with high pressure jet.
Cleaning agents can increase the cleaning effect if they are used correctly!
Always follow/consider the safety instructions of the used product!
• Cold water (high pressure) cleaning: removal of (mild) impurities/pollution and
rinsing.
• Hot water (high pressure) cleaning (if applicable): the cleaning effect will be
such improved through increasing the temperature (set the temperature
experimentally according to the application).
• Cleaning via lance with rotating head (if applicable): cleaning method to
remove tough layers of dirt.
• Cleaning using a steam lance (if applicable): this steam function (by
overheating water) is used in 'sensitive' cleaning applications (eg: damage
sensitive surfaces) where there is stubborn dirt (eg: degreaser) is removed by
using steam.
Please note: this application has high cleaning
temperatures and requires various safety measures!
Intended Use: this pressure washer has been developed for use in various
professional applications (eg: building technology, cleaning technology,
industrial, transport sector, ...).
Turn off
When you interrupt or stop the cleaning activities, be sure to bear in mind the
following instructions in order to be able to switch off the cleaner.
LANCE AND SPRAY GUN
Uncouple the lance and put it away. Put the operating switch on OFF.
Close the water supply. Roll up the high and low pressure hoses.
CLEANER
Drain off the water from the supply tank (by means of a drain off tap beneath
the trailer). If necessary, clean the water filter(s). Slightly clean the cleaner with
a tissue. Close the protection cover and bolt the locks. Hold the manual and the
ignition keys within arm's reach. Close the gas supply valves of the CNG tanks
fully when turning off the cleaner.
The valves must be re- opened completely when
you put the machine back into service.
WATER OUTLET
See chapter "Safety – general warnings" on page 9 & "1 Accomplisch
water supply" on page 15 .
PUT AWAY CLEANER
Store the cleaner in a dry and frost free place at a horizontal and stable subsoil.
Pull the trailer brake and/or place the wheel locks. Turn the jockey wheel
downwards and bolt it. Uncouple the safety cable as well as the electricity wire
from the trailer. Uncouple the drawbar JMB-M from the towbar.
Store the cleaner preventively in an area free from possible
ignition sources! Make sure this area is well ventilated!
Use of a gas detection meter is recommended.
DiBO 34