Dibo JMB-MG Mode D'emploi page 136

E N
AC T I VAT I O N
7 Control Screen 2 (Temperature setting)
In this screen you can set the desired burner temperature. Move the control
stick upwards (raise temperature) or downwards (lower temperature) to set the
desired temperature. Increase/decrease can be done in steps of 5 °C. Turn off
burner immediately: Move the control stick quickly up / down. Minimum value 0
°C - Maximum set point: depending factory setting. Operate to the left: return to
the main screen (at each other screen, same principle).Operate to the right:
navigate to the next operation menu (at each other screen, same principle).
At the top, the current (actual) temperature is visualized and left the burner
indication.
8 Control Screen 3 (Engine speed setting)
In this screen you can set the desired engine speed. The basic setting at
the start is set at 50%. Move the control stick upwards (increase speed) or
downwards (lower speed) below to set the desired engine speed. Increase/
decrease in steps of 10%. Minimum value 0% - maximum value 100%.
At the top right, the current pressure is visualized.
Pay attention: If the key contact is put into position "ON" , the engine
speed is not adjustable. Start the key contact by before the engine
speed is adjustable!
9 Control Screen 4 (Lighting - optional)
In this screen you can set the lighting. Move the control stick upwards (work
light on/off) or downwards (beacon light on/off) to set the desired condition.
Push the control stick to activate, push again to deactivate.
10 Control Screen 5 (transfer pump - optional)
In this screen you can turn on / off the transfer pump.
Move the control stick upwards (turn on) or downwards (turn off).
DiBO 30
.