Textron Ransomes Frontline 728 Manuel De L'opérateur Et De Sécurité page 24

GB
CUTTERDECK
CUTTERDECK BELT TENSION
Verify belt tension after every 50 hours of operation.
The rear span of the cutterdeck belt at W should
deflect 1/2" with a 4-6 lb force applied.
1. If more than 1/2", remove the spring and move
bolt X to next hole. Reattach spring.
2. If necessary, loosen bolt, holding bracket S and
move bracket S for a 1/8" gap between rubber
bumper and bracket I.
Figure 2
DECK LATCH
When raising a deck for servicing, attach deck
latch L to the tractor floorboard.
GB-22
RANSOMES 700 Series EC Tractors
SAFETY AND OPERATORS MANUAL