Textron Ransomes Frontline 728 Manuel De L'opérateur Et De Sécurité page 20

GB
ADJUSTMENTS
ALTERNATOR
Depress the belt at the center between the
crankshaft and alternator pulleys with a force of 11
lb (5 kg). The belt should deflect approximately 0.2"
(5 mm).
Adjust as follows:
a) Loosen the pivot bolt at the base of the
alternator.
b) Loosen the top bolt T and rotate the alternator
along the guide to increase or decrease the
belt tension.
c) While holding the alternator at that location,
tighten bolt T.
d) Finally, tighten the pivot bolt.
e) Verify belt tension, and repeat adjustment
procedure if still found incorrect.
WHEEL ADJUSTMENTS
The rear wheels should be 1/8" (3.2 mm) closer
together at the front than at the back of the wheels.
To adjust wheel toe-in
1. Loosen locknuts L at each balljoint near the
rear wheels.
2. Rotate tie rod H until the wheel is correctly
positioned.
3. Re-tighten locknuts.
To adjust steering shaft
Loosen nut M and rotate steering shaft in cylinder
to provide full steering right and left. Side of arm R
should contact pin E. Check for both sides.
GB-18
RANSOMES 700 Series EC Tractors
SAFETY AND OPERATORS MANUAL