Cutterdeck - Textron Ransomes Frontline 728 Manuel De L'opérateur Et De Sécurité

GB

CUTTERDECK

HEIGHT OF CUT
Cutting height is determined primarily by three adjustments: caster wheel mounting, caster wheel spacers
and deck hanger pins. These adjustments may be made in any sequence but must be the same for both
sides of the deck. Refer to the accompanying Height of Cut Chart for specific settings.
NOTE: Never attempt to change the height of cut or service a cutterdeck without first turning off the PTO and
stopping the engine.
1. Caster Mount - The caster wheel mounting
brackets may be attached to deck mounting
plates P at two different points. Select either
the HIGH or the LOW mounting position for the
two height of cut ranges.
GB-20
RANSOMES 700 Series EC Tractors
SAFETY AND OPERATORS MANUAL
2. Caster spacers - Spacers may be moved from
below to above the pivot spindle E to make
relatively small changes in the height of cut.
a) Remove quick pin Q from the top of the caster
shaft, and remove the wheel completely from
pivot spindle E.
b) Select the spacers needed and place on the
wheel pivot shaft.
c) Reinsert the shaft into the pivot spindle.
d) Place the remaining spacers on the shaft
above pivot spindle E. Replace the quick pin.