Operation Mode / Pulse - Ecolab Elados EMP IV E60 Notice Technique

10.2.2.2 Display in the operating display/ Setting
The metering rate can be configured/adjusted in the operating display during operations.
If the newly set value is not confirmed within 10 seconds by pressing the START/STOP
NOTE
key, the system reverts to the primarily value.
Fig. 10.4
Fig. 10.5
Fig. 10.6
10.2.3

Operation mode / pulse

For the "pulse" operation mode, the metering pump only works in conjunction with incoming
pulses (e.g. from a contact water meter).
The following pulse processing options can be selected:
•
Multiplication
•
Division
417101799_EMP_IV_E60.docx
Strokes/min
Percent (%)
Liter/min
Incoming pulses are multiplied by a configurable factor (n):
1 pulse = n pump strokes (default setting)
Incoming pulses are divided by a configurable factor (n):
n pulse = 1 Pumpenstroke
90
80
70
60
50
40
30
20
10
0
1. Qrtl. 2. Qrtl. 3. Qrtl. 4. Qrtl.
Gallons/day
Fig. 10.7
- 90 -
Ost
West
Nord
Rev. 9-06.11