Presser Foot Lifter; Changing The Presser Foot; Removing And Attaching The Foot Holder - Janome Marie OsmondQC Manuel D'instructions

Janome Marie Osmond Instruction Manual
q
w
q
www.toews.com
w
q
w
e
r
e

Presser Foot Lifter

The presser foot lifter raises and lowers the presser foot.
You can raise it about 1/4˝ (0.6 cm) higher than the normal
up position for easy removal of the presser foot, or to help
you place thick material under the foot.
q Presser foot lifter
w Higher position

Changing the Presser Foot

CAUTION:
Turn off the power switch before changing the foot. Always
use the proper foot for the selected pattern. The wrong foot
can cause the needle to break.
• To remove
Raise the needle to its highest position by turning the hand
wheel counterclockwise.
Raise the presser foot, and press the red button on the
back of the foot holder.
• To attach
Place the selected presser foot so that the pin on the foot
lies just under the groove on the foot holder.
Lower the presser bar to lock the foot into place.
Each foot is marked with a letter for identification.
q Snap-on button (red button)
w Groove
e Pin
r Identification letter

Removing and Attaching the Foot Holder

• To remove
Raise the presser foot lifter and remove the thumb screw
by turning it counterclockwise with a screwdriver.
Remove the foot holder.
• To attach
Match the hole in the foot holder with the threaded hole in
the presser bar.
Fit the thumb screw into the hole.
Tighten the screw by turning it clockwise with
a screwdriver.
q Thumb screw
w Foot holder
e Presser bar
Marie Osmond Owners Manual/ User Guide
30
Janome Sewing Machine