Janome Marie OsmondQC Manuel D'instructions page 154

Janome Marie Osmond Instruction Manual
Message
to
F1 ERROR
It is normal that a faint humming sound is coming out from the internal motors.
Audible Signals
BEEP
pip
pip-pip-pip
www.toews.com
Problem/Cause
The foot control is disconnected while sewing.
• The start/stop button is pressed after the foot
control has been connected.
• Power switch is turned on while depressing
the foot control.
• The machine is malfunctioning due to a
problem in its electronic components.
• The sub needle plate mechanism fails to
operate properly.
• The LCD screen shows an abnormal display.
Beep sounds during:
Normal operation
Invalid operation
Marie Osmond Owners Manual/ User Guide
153
Janome Sewing Machine
Remedy
Turn OFF the power and
connect the foot control.
Disconnect the foot control
and restart the machine.
Release the foot control.
Contact the service center or
the store from where the
machine was
purchased.
Raise the presser foot and turn
the power switch off.
Clean the hook area, then turn
the power on again.
Turn the power switch
off and turn it on
again.