Warning Messages - Janome Marie OsmondQC Manuel D'instructions

Janome Marie Osmond Instruction Manual

Warning Messages

If a buzzer sounds and the LCD screen shows one of these messages, follow the guidance below.
Message
www.toews.com
Problem/Cause
• The machine is started with the presser foot up.
• The machine will stop if the presser foot is raised
while sewing.
• The machine will stop after several stitches if the
buttonhole is sewn without lowering the
buttonhole lever.
• The twin needle button is pressed when a pattern
unsuitable for twin needle sewing has been
selected.
• An unsuitable pattern is selected when the twin
needle mode has been activated.
• The machine is stopped while sewing a locking
stitch.
• The machine is started soon after it has
halted due to overloading.
• Bobbin winder spindle locks during bobbin
winding.
• The machine is turned on when the needle is in
the down position.
• The machine is turned on when the needle is in
the down position and the bobbin winder spindle
is shifted to the left.
• The elongation button is pressed when a pattern
that cannot be elongated has been selected.
• The memory button is pressed when a pattern that
cannot be programmed has been selected.
152
Janome Sewing Machine
Remedy
Lower the presser
foot and start the
machine again.
Lower the buttonhole
lever and start the
machine again.
Cancel the twin needle
mode, and sew with a
single needle.
Sew until it automatically
stops.
Wait for at least 15
seconds to restart.
If thread jamming causes
overload, remove the
tangled threads.
Turn off the power and
remove tangled thread.
Press the up/down needle
position button to raise the
needle.
Turn the hand wheel to
raise the needle.
Select satin stitches to
be elongated.
Select the equivalent
patterns from mode 2.
Marie Osmond Owners Manual/ User Guide