Table des Matières
Publicité
q
e
w
q
q
w
w
q
Presser Foot Lifter
The presser foot lifter raises and lowers your
presser foot.
You can raise it about 0.6 cm (1/4˝) higher than
the normal up position for easy removal of the
presser foot or to help you to place heavy fabric
under the foot.
q Lowest position
w Normal up position
e Highest position
To Attach and Remove the Presser Foot
To remove
Turn the handwheel toward you to raise the
needle to its highest position. Raise the presser
foot. Press the lever on the back of the foot holder.
The presser foot will drop off.
q Lever
CAUTION:
Turn off the power switch when changing the
presser foot.
To attach
e
Place the presser foot so the pin on the foot lines
up just under the groove of the foot holder.
Lower the foot holder to lock the foot in place.
w Groove
e Pin
To Attach and Remove the Foot Holder
q Thumb screw
w Foot holder
e Presser bar
To remove
Remove the thumb screw q by turning it
counterclockwise with a screwdriver.
e
To attach
Match the hole in the foot holder w with the
threaded hole in the presser bar e. Fit the
thumb screw q into the hole. Tighten the
screw q by turning it clockwise with screwdriver.
8
Publicité
Table des Matières
