Table des Matières
Publicité
q
w
BH
4
1
3
2
q
q
w
Corded Buttonhole
e
q Pattern selector:
w Presser foot:
e Thread tension:
z With the buttonhole foot raised, hook the
cord on the cord spur at the back of the
buttonhole foot.
q Spur
x Bring the ends toward you under the
buttonhole foot until they clear the front end.
c Hook the filler cord into the forks on the front
of the foot to hold them tight.
v Lower the needle into the garment where the
buttonhole will start and lower the foot.
b Depress the foot control gently and sew the
buttonhole. Each side of the buttonhole and
the bartacks will be sewn over the cord.
n Remove the fabric from the machine and cut
the sewing threads.
m Pull the left end of the filler cord to tighten it.
, Thread the end through a darning needle,
draw to the wrong side of the fabric and cut.
Zipper Application
e
q Pattern selector:
w Presser foot:
e Thread tension:
Pin or baste zipper tape to fabric and place it
under the foot.
Smooth the threads toward the back and lower
the foot.
To sew the left side of the zipper, guide the
zipper teeth along the edge of the foot and stitch
through the garment and zipper tape.
Turn the fabric and sew the other side of the
zipper in the same way as you did the left side.
30
(BH)
Sliding buttonhole foot
1 – 5
A1
Zipper foot
2–6
Publicité
Table des Matières
