IT
4.6.2 Revisione valvola della compressione
4.6.2.1 Smontaggio
•
Prestando la massima attenzione a non danneggiare le
lamelle, bloccare in morsa, la valvola di compressione
(43), sfruttando le superfi ci parallele, evitando di eccedere
nel serraggio.
•
Svitare la vite (36), servendosi di una chiave da 12 mm.
•
Rimuovere nell'ordine, la vite (36), la molla (37), la
lamella di by pass (38), il pistone (39) completo anello o-
ring (40), la lamella o il pacco di lamelle che regolano la
compressione (41).
60
EN
4.6.2 Compression valve overhauling
4.6.2.1 Dismantling
•
Being very careful not to damage the washers, clamp the
compression valve (43) into the vice, exploiting the parallel
surfaces and without over-tightening.
•
With a 12 mm spanner, unscrew nut (36).
•
In sequence, remove the nut (36), the spring (37), the by-
pass washer (38), the piston (39) with O-ring (40) and the
washer or washers' stack which regulate compression (41).
12 mm
40
36
43
36
37
38
39
41