Maintenance; General - Dibo JMB-S Mode D'emploi

1 low pressure coupling
2 safety valve
3 high pressure hose coupling
Tip: You can re- use the collected water with antifreeze several times.
When the cleaner is put back into service:
• Fill the tank with water and start the cleaner.
• Capture the antifreeze till water flows out of the spray gun (see below).
2 O P T I O N : F I L L K I T A N T I F R E E Z E ( S E E P I C T U R E B E LOW – 1 . 2 3 0.1 0 0 / 1 0 1 / 1 0 2 )
First loosen the basket from the water filter. Connect the filling set antifreeze to
the low pressure coupling and to the high pressure hose (closed circuit).
Put the cleaner on idle speed and operate the spray gun.
Keep the spray gun pressed till there is filled with antifreeze to the water filter.
Turn the basket back on the filter and then push again on the spray gun.
Hold the spray gun until also the water filter (note the color of antifreeze in the
water filter) is filled with antifreeze (+- 20 litres).
Turn off the cleaner and disconnect the antifreeze filling set of the hoses.
The low pressure side is now also filled with antifreeze.
2
1
3

Maintenance

GENERAL

All maintenance activities must happen at an disconnected machine and
hoses without pressure. Allow to cool down the cleaner before performing
maintenance activities! Checking the electric components can happen
exclusively by an expert. Exclusively accessories and replacement components
which have been approved by the manufacturer can be used. Directly after
the activities all securities- and protection parts must be assembled, before
the machine is put in functioning. "A golden rule" that contributes to a perfectly
working machine with few problems, is well the following:
A DAILY CONTROL AND CLEANING OF THE
MACHINE FREQUENTLY DO WONDERS!
To be able to guarantee a perfectly working system, one has first necessary a
reliable and technical well considered machine, which is then faced secondly
at regular times with a thorough maintenance. Therefore the experience and
the "know-how" of DiBO a technical good working machine is insured and large
maintenance turns can be carried out by experienced DiBO technicians by
means of appointment or maintenance contract, we can suppose in advance
that it is satisfied to these two points.
DiBO 33
E N
M A I N T E N A N C E