Description Daily Control; Trailer; Valves + Pressure Gauge; High Pressure Pump - Dibo JMB-S Mode D'emploi

DESCRIPTION DAILY CONTROL

1

Trailer

Check the trailer in its entirety on defects. Pay particular attention to tire
pressure, brakes and hoses, signalisation, hood closure, screws coming
loosened , cracks and/or breakages necessary to be able to participate in traffic
safely and in accordance with the law. Keep the machine clean to the extent
possible to prevent dirt, water, oil and spilled fuel having a unfavorable effect.
2

Valves + pressure gauge

The pressure gauge must reflect 0 bar at a switched off machine (stopped
engine). At a maximum performing machine (operated at full load working
engine), the pressure gauge cannot indicate more than the maximum pressure
by DiBO indicated, for your machine. After operation and releasing the spray
gun there can still remain a small pressure remainder. The reflected value of the
pressure gauge must be between 0-30 bar, the valves are correctly in this case.
3

High pressure pump

Check the pump on loose connections, bolts, seals and leaks. Check regularly
the oil level of the pump. If the oil level has decreased too much or pollution of
oil is detected, these should be replaced before working further.
Put the machine on a horizontal base. The oil level must stand halfway the level
glass. Take at doubt the oil level stick separately, where the oil level must stand
between both mark lines. If pump oil gives a milky impression, this frequently
indicates on an internal leak as a result of which water touched oil there.
Immediately repair in this case.
4

High pressure parts and low pressure parts

Check the hoses, piping and connections on external damages and leaks.
If damaged or leaks these must be immediately replaced.
5

Spray equipment

Check lances and guns on leaks, external damages and hair cracks.
If damaged or leaks these must be immediately replaced. Check the spray
image of the water jet, if these blows out to much you must replace the nozzle.
Check protective cap-nozzle on damages and replace if necessary.
Check the thread of the couplings on external damages.
At any damage replace without delay.
6

Electric parts

Check visible electric wiring and components (among other things switches) on
external visible damages. If damaged replace the concerning parts immediately.
7

Burner

Check if the burner opening is clear of pollution. Checks pipes and connections
on leaks and external damages. Check the filter and replace if necessary.
Check the sort fuel and the pollution in the tank and clean if necessary.
Ignition transformer burner:
It is important that on the ignition transformer a load is
connected. The switching on of the ignition transformer
without the ignition pins are connected, are not permitted. We
recommend during maintenance activities certainly checking
the connections of the ignition cables and for the case the
burner would not work, certainly don't let run the burner.
8

Water tank

Check the water tank on external damages and leaks.
Check when the tank is filling if the float system works properly.
9

Engine

Check the engine for loose parts, leaks. Check the oil level with the oil gauge.
When the oil level has gone down too much, or contamination of the oil is found,
this must be replaced before continuing the works.
Check that the intake opening is not blocked.
Check the filter for extreme contamination and clean / replace it if necessary.
Check the filter for contamination and clean / replace it if necessary.
DiBO 37
E N
M A I N T E N A N C E