Cleaning Fuel Filter And -Tank; Cleaning Of Internal Chemical Tank; Maintenance At Expense Of Dibo Technician; Description Daily Control - Dibo IBH Mode D'emploi

5 Cleaning fuel filter and -tank
Dismantle the fuel filter, and replace. Empty the fuel tank. Take care for
tightened fuel hoses (clamps on the conduits!) to the fuel filter at a replacement!
Remove the drain plug and catch possible dirt in a barge. Rinse the tank with a
little bit off clean fuel and unbolt the drain plug.
6

Cleaning of internal chemical tank

At the internal tank one has to clean the tank with high pressure water. Don't
forget to uncouple the drain plug to remove the dirty water with chemicals out
of the tank. Rinse (if necessary) and remove the dirty water back out of the tank.
7

Maintenance at expense of DiBO technician

For further maintenance (burner, engines, high pressure pump and parts who
has to do with safety) we advise to contact your DiBO distributor concerning
a maintenance contract. The maintenance applies to normal company
circumstances. At heavy circumstances you can communicate this so that can
be taken into account. Supplement documents:
• Control manual
• CE- certificat
Remarks: We advise the owner/user at strongest to make an appointment with
DiBO against reaching the given up company hours, to be able to guarantee a
good and regular maintenance concerning a maintenance turn.

DESCRIPTION DAILY CONTROL

1

Frame

Check the frame in its entirety at loose bolts and/or cracks of the welds.
Keep the machine as much as possible clean to prevent act on dirt, water, oil
and messed fuel.
2

Valves + manometer

At a switched off machine, this means a halted engine, the manometer must
reflect 0 bar. At a maximum performing machine, this means operated at full
load working engine, the manometer can not indicate more than the maximum
pressure by DiBO indicated, for your machine. After serving and releasing
the spray gun, there still can remain a small pressure remainder present in the
conduits. The reflected value of the manometer must be between 0-30 bar, the
valves are then all right. At FULL version the pressure will be reflected on the
display.
3

High pressure pump

Check the pump on loose connections, bolts, seals and leaks. Puts the machine
on a horizontal base. The oil level must stand halfway the level glass. Take at
doubt the oil level stick separately, where the oil level must stand between both
mark lines. If pump oil gives a milky impression, frequently indicates this on an
internal leak as a result of which water touched oil there. Immediately repair by
a DiBO- technician is necessary then.
4

High- and Low pressure part

Check the hoses, piping and connections on external damages and leaks. If
damaged or if there are leaks, these must be replaced immediately.
5

Spray tools

Check lances and guns on leaks, external damages and hair cracks. If damaged
or if there are leaks, these must be replaced immediately.Check the spray
image of the water jet, if these blows out to much you must replace the nozzle.
Check protective cap-nozzle on damages and replace if necessary. Check the
thread of the couplings on external damages. At damage, replace these directly.
6

Electrical part

Checks visible electric wiring and components (among other things: switches)
on external visible damages. If damaged, replace the concerning parts
immediately.
DiBO 25
E N
S E R V I C E