Trailer - Dibo JMB-S Mode D'emploi

TRAILER

1 C O N N E C T I N G T H E TOW B A L L C O U P L I N G
• Move the ball coupling over the trailer device.
• Open and hold the ball coupling.
• Turn the jockey wheel handle clockwise until the ball coupling locks in place.
• Continue to turn the jockey wheel handle until the wheel is fully retracted. The
support shoe must be firmly engaged in the recess in the outer tube.
• Open the clamp.
• Pull the jockey wheel upwards as far as possible.
• Tighten the clamp.
• Connect the power cable to the towing vehicle.
• Route the breakaway cable through the breakaway cable guide ring and
loop it around the ball plate (see also the applicable country regulations for
potential possibilities through coupling!).
• Release the hand-brake lever.
• Remove wheel blocks.
Note: The ball coupling consists of safety indicator (controls if
the coupling is secured). See abbreviated clarification below.
2 C O U P L I N G T H E TOW I N G E Y E
• Couple the towing eye in the coupling jaw.
• Turn the jockey wheel handle clockwise until the wheel is fully retracted.The
support shoe must be firmly engaged in the recess in the outer tube.
• Open the clamp.
• Pull the jockey wheel upwards as far as possible.
• Tighten the clamp.
• Connect the power cable to the towing vehicle.
• Route the breakaway cable through the breakaway cable guide ring and loop
it around the ball plate.
• Release the hand-brake lever.
• Remove wheel blocks.
3 O P E R AT E T H E H A N D B R A K E
Applying: pull the hand-brake lever beyond the noticeable dead- center
position. Releasing: press the locking button and keep it pressed.
Push the hand-brake lever back through the dead- center position to its original
position.
Always pull the hand-brake lever fully!
DiBO 29
E N
O P E R AT I O N