Operating Components - Dibo JMB-S Mode D'emploi

OPERATING COMPONENTS

General: Always set the key switch to position
'OFF' when you drive on the public roads!
See chapter "Visual perception" on page 15 to check the components.
1 K E Y S W I TC H
The main switch is the key switch and is carried out with three positions:
• ON: The JMB will be switched on electrically without however starting the
engine. After switching on, all sensors will be tested automatically and the
glowing process of the engine starts.
• START: When the indication "preheating" is faded, the engine can be started.
• OFF - STOP: By turning the key to the left the engine will be switched off.
2 C O N T R O L S T I C K
The control stick is a switching element with four possible switching positions
(left/right/above/below) and a zero position (middle). This coordinate switch is
suitable for simple navigation in the 4 selectable directions.
3 D I S P L AY
On the display you receive possible disturbances and the operating instructions
will be displayed if desired. You also receive a message when service is
necessary / desired, receive status info of the cleaner and check working hours
of the machine. Other operating possibilities will be displayed by means of
operating the control stick ( "1 Settings with control stick" on page 25 ). The
functioning of the control panel will be described further in this chapter.
4 E M E R G E N CY S TO P
The emergency stop can be recognized by a red pushing button and a
yellow slice. The display screen will be disappeared (powered off) when the
emergency stop is pushed.
• Push the emergency stop: the machine stops immediately at emergency
situations.
• Pull out the emergency stop: the machine can be restarted.
5 F U S E S
The electrical part off the JMB is protected by different fuses. These fuses are
mounted in the electric box which is mounted against the burner.
The fuse for the sparking plug is mounted on the left side and is accessible by
opening the cover.
6 H I G H P R E S S U R E H O S E W I T H S P R AY G U N
The high pressure hose is coupled rotated on the spray gun. Also assemble
(tighten) the lance to the spray gun. Because of that you obtain a high degree of
free movement during the spraying activities.
Check regularly if the lance coupling is still fixed
to the spray gun during spraying activities.
Spray gun
• Do not spray: release the lever in the handle.
• Spraying: push the lever in the handle.
• Spray security: release the blocking pawl in the handle.
• The machine is standard equipped with a single lance.
When changing the spraying tool, always turn off the cleaner first!
DiBO 23
E N
O P E R AT I O N