Functioning; Set To Work; Control Components - Dibo JMB-M 500/30 Mode D'emploi

27 P R O F E S S I O N A L S W I TC H M O D E B AT T E RY C H A R G E R ( O P T I O N )
The trailer with track & trace will be standard equipped with a charging cable
(1.701.075) to connect any professional switch mode battery charger (1.701.210)
on the battery.
Pay attention: the battery may not be charged constantly!
The trailer (machine) may not be switched on at any
circumstances during the charging procedure!
For info: If the battery clamps are incorrectly connected, the reverse polarity
protection will ensure that the battery and charger are not damaged.
Estimated time for charging (for an empty battery): +- 20h. The charger is
designed for charging only for batteries according to the technical specification.
See also the delivered manual of the professional switch mode battery charger.
28 C A P P R OT E C T I O N ( O P T I O N )
The trailer can optionally be equipped with a cam switch, which will give an
alarm on the diplay when the protective cover is open (see further in the case of
malfunctions).

Functioning

SET TO WORK

Turn the key contact to position 1 (=ON) and wait till the lamp of preheating is
extinguished, then turn the key contact further to position 2 (=START) to start the
fuel engine. Leave the key when the fuel engine is started. The automatic speed
control option has a fixed setting on 50 %. When the fuel engine is running,
allow the engine to warm up at stationary revolutions. Point the spray gun in to
the open space and operate the spray gun until the water supply is completely
de aerated. Operate the spray gun and adjust if necessary the spray pressure
by operating the control stick. For the use of hot water, set the temperature
on desired value through the control stick and by following the instructions
of the temperature menu on the display (see "Display / failures" on page
26 ). After turning 30 minutes into bypass, the cleaner will switch off and an
indictaion will be visualized on the display.
Pay attention: the cleaner can start automatically in stand- by position!

CONTROL COMPONENTS

1 K E Y S W I TC H ( S E E A L S O :
The main switch is a key switch and is equipped with three positions:
• ON: The JMB will be switched on electrically without however starting the
engine. After switching on, all sensors will be tested automatically and the
glowing process of the engine starts.
• START: As soon as the indication (image left) is gone, the engine can be
started.
• STOP: By turning the key back to the left the engine will be switched off again.
Wait until the machine is started completely
(until the indication disappears)!
2 C O N T R O L S T I C K
The control stick is a switching element with four possible switching positions
(left/right/above/below) and a zero position (middle). This coordinate switch is
suitable for simple navigation in the 4 selectable directions.
3 D I S P L AY
On the display you receive possible disturbances and the operating instructions
will be displayed if desired.
You also receive a message when service is necessary / desired, receive status
info of the cleaner and check working hours of the machine.
Other operating possibilities will be displayed by means of operating the control
stick (see "Display / failures" on page 26 ). The functioning of the control
panel will be described further in this chapter.
DiBO 23
" V I S UA L P E R C E P T I O N " O N PAG E 1 6 )
E N
F U N C T I O N I N G