Control Components - Dibo JMB-M Mode D'emploi

E N
AC T I VAT I O N

CONTROL COMPONENTS

See chapter: "Visual perception" on page 15 .
1 K E Y S W I TC H
The main switch is a key switch and is equipped with three positions:
• ON: The JMB will be switched on electrically without however starting the
engine. After switching on, all sensors will be tested automatically and the
glowing process of the engine starts.
• START: As soon as the indication "preheating" is gone, the engine can be
started.
• STOP: By turning the key back to the left the engine will be switched off again.
2 C O N T R O L S T I C K
The control stick is a switching element with four possible switching positions
(left/right/above/below) and a zero position (middle). This coordinate switch is
suitable for simple navigation in the 4 selectable directions.
3 D I S P L AY
On the display you receive possible disturbances and the operating instructions
will be displayed if desired. You also receive a message when service is
necessary / desired, receive status info of the cleaner and check working
hours of the machine. Other operating possibilities will be displayed by means
of operating the control stick. The functioning of the control panel will be
described further in this chapter.
4 E M E R G E N CY S TO P
The emergency stop can be recognized on the red pressing button at a yellow
slice.
• Push the emergency stop: the machine stops immediately at emergency
situations.
• Pull out the emergency stop: the machine can be restarted.
The display screen will be disappeared (powered off) when the emergency stop
is pushed.
5 F U S E S
The electrical part off the JMB is protected by different fuses. These fuses are
mounted in the electric box which is mounted against the burner. The fuse for
the sparking plug is mounted on the left side and is accessible by opening the
cover.
6 H I G H P R E S S U R E H O S E W I T H S P R AY G U N
The high pressure hose is coupled rotated on the spray gun. Also assemble
(tighten) the lance to the spray gun. Because of that you obtain a high degree of
free movement during the spraying activities.
Check regularly, during spraying activities, whether the
lance coupling is still fixed to the spray gun.
Spray gun
• Do not spray: release the lever in the handle.
• Spraying: push the lever in the handle.
• Spray security: release the blocking pawl in the handle.
The machine is standard equipped with a single lance. When changing the
spraying tool, always turn off the cleaner first!
DiBO 22