Electrical Connection; Break Time; Pumps Ht - Dibo JMB-M Mode D'emploi

E N
AC T I VAT I O N
4

Electrical connection

Connection diagram for 7- pole plug:
INDICATION
L
54G
31
R
58R
54
58L
Connection diagram for 13- pole plug:
NUMBER
1
2
3
4
5
6
7
8
9
10
11
12
13

BREAK TIME

The spraying can be stopped arbitrarily by releasing the handle off the spray
gun. Next acts one must comply, if the spraying pause last longer than ten
minutes (or by abandoning the working area):
• After cleaning at use of the burner, the temperature must be 0°C and you
have to spray during at least an other 5 minutes for cooling down the burner
sufficiently.
• When you decide to switch between steam function and high pressure
function: rince with cold water during 10 minutes (cooling down).
• Switch off the machine completely. Put therefore the key contact to position
"0".
• Release the pressure of the pressure hose by pushing the handle of the spray
gun for a moment.

PUMPS HT

There must be present a pre - pressure (pump) at HT pumps (pumps with high
temperature). The pre - pressure (pump) must provide for sufficient flow of
water to feed the high pressure pump and to occur cavitation. Cavitation is
the phenomenon that in a moving fluid the local pressure is going to be lower
than the vapour pressure of the fluid. Because of this mist bells will arise who
can implode with high power in the pump and could cause damages. For all
these applications at high temperature, it is ABSOLUTELY ESSENTIAL to feed
the pump with positive pressure (at least 3 bar) and with a sufficient quantity of
water.
DiBO 28
COLOUR
yellow
blue
white
green
brown
brake lights : left &
red
black
COLOUR
yellow left indicator
blue
white mass (for poles 1-8)
green right indicator
brown right rear light
brake lights : left &
red
black left rear light
grey reversing light
white/black mass (for poles 9-12)
NAME
left indicator
fog lamp
mass
right indicator
right rear light
right
left rear ligh
NAME
fog lamp
right