Service; General; Maintenance Diagram General; Periodic Maintenance - Dibo JMB-C+ WWC Mode D'emploi

E N
S E R V I C E

Service

GENERAL

All maintenance activities must happen at an disconnected machine and hoses
without pressure. Checking the electric components can happen exclusively by
an expert. Exclusively accessories and replacement components which have
been approved by the manufacturer can be used. Directly after the activities all
securities- and protection parts must be assembled, before the machine is put
in functioning. "a golden rule" that contributes to a perfectly working machine
with few problems, is well the following:
A daily control and cleaning of the machine frequently do wonders!
To be able to guarantee a perfectly working system, one has first necessary a
reliable and technical well considered machine, which is then faced secondly
at regular times with a thorough maintenance. Therefore the experience and
the "know-how" of DiBO a technical good working machine is insured and
large maintenance turns can be carried out by experienced DiBO technicians
by means of appointment or maintenance contract, we can suppose in advance
that it is satisfied to these two points.
MAINTENANCE DIAGRAM
1 General
Check daily by means of the maintenance diagram the high pressure cleaner.
You find the maintenance diagram on the following pages. Check even all
transmission belts on good tension and possible defects. If this case is not, then
best consult the proper maintenance technicians.
PAY ATTENTION: Take care that the transmission belts aren't
in movement and observe the applying safety standards!
2

Periodic maintenance

DISCRIPTION
Control of the electric cables, high and low pressure
hoses - couplings and control of the oil level.
Checking the transmission belts.
Refreshing vacuum pump oil.
Refreshing pump oil.
Refreshing reduction gearbox oil.
Cleaning water filter.
Replacement and cleaning oil filters and fuel filters.
Cleaning fuel tank.
All following refreshments of pump oil and reduction
Maintenance motor.
Extra control/replacement of joints, valves, O- rings
by acknowledged DiBO- technicians.
DiBO 28
gearbox oil.
PERIOD
After each use.
First 10-20 hours.
Yearly, check also the
adjusted manual of
the vacuum pump.
First 50 hours.
First 50 hours.
Each 50 hours.
First 50 hours, each
following 250 hours.
First 50 hours, each
following 250 hours.
Each 250 hours.
See enclosed motor
instruction manual.
Each 750 hours.