Dibo JMB-C+ WWC Mode D'emploi page 120

E N
AC T I VAT I O N
3 C O N T R O L S C R E E N 3 ( E N G I N E S P E E D S E T T I N G - O P T I O N A L )
In this screen you can set the desired engine speed. The basic setting at the
start is set at 50%.
Pay attention: If the key contact is put into position
"ON" , the engine speed is not adjustable. Start the key
contact by before the engine speed is adjustable!
Move the control stick upwards (increase speed) or downwards (lower speed)
below to set the desired engine speed. Increase/decrease in steps of 10%.
Minimum value 0% - maximum value 100%. At the top right, the current pressure
is visualized.
4 C O N T R O L S C R E E N 4 ( L I G H T I N G - O P T I O N A L )
In this screen you can set the lighting. Move the control stick upwards (work
light on/off) or downwards (beacon light on/off) to set the desired condition.
Push the control stick to activate, push again to deactivate.
5 C O N T R O L S C R E E N 5 ( F I L L I N G P U M P - O P T I O N A L )
In this screen you can turn on / off the filling pump. Move the control stick
upwards (turn on) or downwards (turn off)..
6 C O N T R O L S C R E E N 6 ( VAC U U M P U M P )
In this screen you can turn on / off the vacuum pump. Move the control stick
upwards (turn on) or downwards (turn off). Operate to the left/right: return to the
main screen.
When activated, the motor runs and will turn automatically in stationary position.
Now, when the motor turns stationary, the vacuum pump will be coupled
automatically. The vacuum pump will start. The lamp (on display) shall burn. At
pushing again, the lamp of the vacuum pump shall go out (on display). After
coupling, there will be turned back automatically to the adjusted number of revs.
DiBO 24