Water Tank - Dirty Water Tank; Oil Drain High Pressure Pump; Oil Filling High Pressure Pump; Carry Away Used Oil - Dibo JMB-C+ WWC Mode D'emploi

Ignition transformer from the burner: It is important that on the
ignition transformer a load is connected. The switching on of the
ignition transformer without the ignition pins are connected, are not
permitted. We recommend during maintenance activities certainly
checking the connections of the ignition cables and for the case
the burner would not work, certainly don't let run the burner.
8

Water tank - dirty water tank

Check the water tank on external damages and leaks.
Check when the tank is filling if the float system works properly.
9

Oil drain high pressure pump

Put a oil trough under the drain plug. Remove the drain plug. Drain all the oil.
Assemble the drain plug ( with a new packing ring ).
10 Oil filling high pressure pump
Remove the oil-level gauge. Fill the motor crankcase with oil until the oil-level
comes up to the middle of the gauge (oil: "Technical data" on page 35 ).
Check the oil- level on the basis of the marks on the oil- level gauge.
Place back the oil-level gauge.
11

Carry away used oil

Pour the tapped oil in a can. Deliver the tapped oil by your dealership or at the
proper authorities.
12

Motor

Check the motor for loose parts, leaks. Check the oil level with the oil gauge.
When the oil level has gone down too much, or contamination of the oil is
found, this must be replaced before continuing the works. Check that the intake
opening is not blocked. Check the filter for extreme contamination and clean /
replace it if necessary.
13

Fuel tank

Check for damage or leakage and if the findings are negative, have the tank
repaired / replaced. Regularly check the tank for contamination.
14

Recommended lubricants

Lombardini motor: 1.836.005
W 5015 pump: 1.836.042
Misting oil: 1.836.052
15 Oil filling reduction gear box
Remove the oil-level gauge. Fill the gearbox with oil until the oil-level comes up
to the middle of the gauge (type oil see technical data). Check the oil-level on
the basis of the marks on the oil-level gauge. Place back the oil- level gauge.
16

Oil drainage reduction gearbox

Put a bowl under the tap of the reduction gearbox. Open the tap. Let all the oil
through in the bowl. Close the tap.
17

Oil drain motor

Remove the oil- level gauge. Remove the drain plug. Replace the oil filter if
necessary (see manual Lombardini). Let all the oil in the oil trough. Assemble
the drain plug (with a new packing ring).
Notice: The motor crankcase has on both sides a drain plug, which apply that:
Oil may only be drained by way of the drain plug, which distinguish itself by a
bent effluent pipe towards under. Never try to remove oil along the backside.
This can end up in the nearby wiring and effect the machine harmful and even
put is out of company.
18 Oil filling motor
Remove the filler cap on top of the motor. Fill the motor crankcase with oil (type
oil see technical data). Check the oil-level on the basis of the marks on the oil-
level gauge. Place back the filler cap.
DiBO 31
E N
S E R V I C E