Activation; Set To Work; Bedieningscomponenten - Dibo JMB-C+ WWC Mode D'emploi

E N
AC T I VAT I O N

Activation

SET TO WORK

Turn the key contact to position 1 (=ON) and wait till the lamp of preheating is
extinguished, then turn the key contact further to position 2 (=START) to start
the fuel engine. Leave the key when the fuel engine is started. The automatic
speed control option has a fixed setting on 50 % (or place the throttle lever at
position 1/2, depending the selected option). When the fuel engine is running,
allow the engine to warm up at stationary revolutions. Point the spray gun in to
the open space and operate the spray gun until the water supply is completely
de aerated. Operate the spray gun and adjust if necessary the spray pressure
by operating the throttle lever/control stick. For the use of hot water, set the
temperature on desired value through the control stick and by following the
instructions of the temperature menu on the display (see a "Display / failures"
on page 22 ). After turning 30 minutes into bypass, the cleaner will switch off
and an indictaion will be visualized on the display.
Make sure that the valve is on position 'steam function' and the throttle is
on position 'steam function', when you wish to work with steam (at standard
configuration)! Use the appropriate steam equipment!

BEDIENINGSCOMPONENTEN

Zie chapter "Visual perception" on page 15
1 K E Y S W I TC H
The main switch is a key switch and is equipped with three positions:
• ON: The JMB will be switched on electrically without however starting the
engine. After switching on, all sensors will be tested automatically and the
glowing process of the engine starts.
• START: As soon as the indication "preheating" is gone, the engine can be
started.
• STOP: By turning the key back to the left the engine will be switched off again.
2 C O N T R O L S T I C K
The control stick is a switching element with four possible switching positions
(left/right/above/below) and a zero position (middle). This coordinate switch is
suitable for simple navigation in the 4 selectable directions.
3 D I S P L AY
On the display you receive possible disturbances and the operating instructions
will be displayed if desired. You also receive a message when service is
necessary / desired, receive status info of the cleaner and check working
hours of the machine. Other operating possibilities will be displayed by means
of operating the control stick (see "Display / failures" on page 22 ). The
functioning of the control panel will be described further in this chapter.
4 M E R G E N CY S TO P
The emergency stop can be recognized by a red push button with yellow slice.
• Push the emergency stop: the machine stops immediately at emergency
situations.
• Pull out the emergency stop: the machine can be restarted.
The display screen will be disappeared (powered off) when the emergency stop
is pushed.
5 F U S E S
The electrical part off the JMB is protected by different fuses. These fuses are
mounted in the electric box which is mounted against the burner. The fuse for
the sparking plug is mounted on the left side and is accessible by opening the
cover.
6 H I G H P R E S S U R E H O S E W I T H S P R AY G U N
The high pressure hose is coupled rotated on the spray gun. Also assemble
(tighten) the lance to the spray gun. Because of that you obtain a high degree of
free movement during the spraying activities.
DiBO 20