Switch-Over Weighing Unit - KERN and SOHN ABS-N Série Mode D'emploi

10.7 Switch-over weighing unit

By pressing the UNIT key, the display can be switched over to the units enabled before
in the menu.
Call up menu
 In weighing mode press the UNIT key for 3 sec. The
current setting is marked by the stability display ( ).
With stability display ( )
Without stability display ( )
Enable/disable units
 Press TARE
Use the navigation buttons ( ) to select more units and
to enable/disable them as described before.
 Press ON/OFF repeatedly or for 3 sec., the balance will
return into weighing mode
How to change weighing units
 To return to the previously enabled weighing units go to
weighing mode by UNIT.
When switching-on the balance, the unit in which the balance has been
switched off, will be displayed.
36
Unit enabled
Unit disabled


ABS-N_ABJ-NM-BA-e-1614