Target Mode - KERN and SOHN ABS-N Série Mode D'emploi

15.2 Target mode

This mode e.g. is used for weighing constant liquid quantities or for assessment of
missing quantities or excess quantities.
The target value is the numeric value which corresponds to the nominal quantity of the
used unit. Beside the target value a tolerance value is entered. This is a numerical
value which is plus/minus over or under the acceptable target value.
The indicators
,
These indicators are only functioning in check weighing or in target mode, otherwise
they cannot be seen.
The indicators provide the following information:
Condition
Weight more than the nominal
weight and above the upper
tolerance
Weight within tolerance
(target value ± tolerance)
Weight less than nominal
weight and below the lower
tolerance
72
or
advise, when the target value is reached.
Grading
Great difference to target value
Small difference to target value
Target value accepted
Small difference to target value
Great difference to target value
Indicator
flashes slowly
flashes fast
flashes fast
flashes fast
ABS-N_ABJ-NM-BA-e-1614