KERN and SOHN ABS-N Série Mode D'emploi page 173

Further steps depend on the desired setting:
Stability
Function
display ( )
yes
ON
no
off
3. Set output condition
 Use the navigation buttons ( ) to select the desired
mode, e.g. Mode 3 (details see Tab. 1)
 Confirm with TARE
4. If necessary, set condition for zero display
 Press PRINT
 Select the desired adjustment using the navigation keys
( )
RET.0 An other output when the display goes back to zero.
An other output when the display goes back to 50% of the
RET.50%
previous weighing value.
 Confirm with TARE
5. Return to weighing mode
 Press ON/OFF repeatedly or for 3 s. From here on the
Auto Print function is active, the indicator
displayed.
5. Place goods to be weighed on balance
 If necessary, place an empty container on the balance and tare it by pressing
TARE.
 Place weighed goods and wait until the stability display ( ) appears. The
weighing value is issued automatically.
6. Remove the weighed good.
 Wait until the stability ( ) / zero display appears. The weighing value is issued
automatically.
ABS-N_ABJ-NM-BA-e-1614
set/update

Press PRINT and
continue with step 3.

Press TARE and
continue with step 3.
cancel
Press TARE and
continue with step
5.
continue with step
5.
With selection
is
„RET.0"
77