Change Position Of Decimal Dot For Freely Programmable Weighing Unit; Input Minimum Weight For Freely Programmable Weighing Unit - KERN and SOHN ABS-N Série Mode D'emploi

10.7.2 Change position of decimal dot for freely programmable weighing unit

The position of the decimal dot can only be changed by a numeric input of the
conversion factor (see chpt. 9.7.1, step 2).
 When the first cipher flashes, press PRINT repeatedly
until the decimal dot flashes.
 Select the desired position using the navigation keys
( ). If no decimal dot shall be set, press MENU
repeatedly until the display symbol appears.
 Confirm with TARE.
 Press ON/OFF repeatedly or for 3 sec., the balance will
return into weighing mode

10.7.3 Input minimum weight for freely programmable weighing unit

Call up menu
 In the menu item „CONV.K" (see chpt. 9.7.1) use the
navigation buttons to select ( ) „MIN.D".
 Press TARE and current setting will be displayed.
 Use the navigation buttons to enter the desired
minimum weight, see chapter 3.1.1 „Numeric input".
 Press ON/OFF repeatedly or for 3 sec., the balance will
return into weighing mode
38 ABS-N_ABJ-NM-BA-e-1614