KERN and SOHN ABS-N Série Mode D'emploi page 170

 Confirm with TARE.
4. Return to weighing mode
 Press ON/OFF repeatedly or for 3 sec.
5. Start tolerance control
If necessary, place an empty container on the balance and tare it by pressing
TARE.
Place weighed goods and wait until the indicator
the help of the indicator check if the weighed goods are under, inside or over the
default tolerance
Example of entry:
Weight less than nominal
weight and below the lower
tolerance
Weight within tolerance [target
value ± tolerance]
(90.0000g – 110.000g)
Weight more than the nominal
weight and above the upper
tolerance
74
TG.VAL 100.0000 g
10.0000 g
LM.VAL
or
appears. With
,
flashes slowly
flashes fast
flashes fast
flashes slowly
ABS-N_ABJ-NM-BA-e-1614