5. Stop bit settings
Use ON/OFF to return to menu
Press the navigation buttons ( ) repeatedly
until „STOP" is displayed.
Press PRINT. The current setting is marked by the
stability display ( ).
Press the navigation buttons ( ) repeatedly until the
desired setting (e.g. S. 1) appears.
Press TARE.
Selectable settings:
Display
Stop bit
6. Set handshake
Use ON/OFF to return to menu
Press the navigation buttons ( ) repeatedly
until „HAND.SHK" is displayed.
Press PRINT. The current setting is marked by the
stability display ( ).
Press the navigation buttons ( ) repeatedly until the
desired setting (e.g. HS.HW) appears.
Press TARE.
Selectable settings:
Display
HS.OFF
Hand-
No handshake
shake
86
S. 1
1 bit
HS.HW
Hardware
handshake
S. 2
2 bit
HS.SW
Software handshake
Timer handshake
ABS-N_ABJ-NM-BA-e-1614
HS.TiM