0. Call up menu
In weighing mode press the MENU button twice
1. Select function
Press the navigation buttons ( ) repeatedly until
„TOOLS" is displayed.
Confirm with PRINT
Press the navigation buttons ( ) repeatedly
until „CHECK.W" is displayed. The current setting is
marked by the stability display ( ).
Further steps depend on the desired setting:
Stability
Function
display ( )
yes
ON
no
off
2. Set limit values
When entering the limit values ensure that the values match logically one
with another, i.e. the lower limit value must not be greater than the upper
one.
If not considered, the balance will adapt the limit values automatically.
Press the navigation buttons ( ) repeatedly until
„HI.LIM" is displayed.
Press TARE. The current setting will be displayed.
Use the navigation buttons ( ) to enter the desired
value, see chpt. 3.1.1 „Numeric input".
ABS-N_ABJ-NM-BA-e-1614
set/update
Press PRINT and
continue with step 3.
Press TARE and
continue with step 3.
cancel
Press TARE and
continue with step 4.
continue with step 4.
69