Application Functions; Parts Counting - KERN and SOHN ABS-N Série Mode D'emploi

14 Application Functions

• The application functions can be combined with the check weighing or
target function (see chpt. 14).
• The balance starts in the mode, in which it has been switched off.
• For switching over between application and weighing mode, press MENU
for 3 sec.

14.1 Parts counting

With parts counting you can either count parts into a container or remove parts from a
container. To count a greater number of parts the average weight per part has to be
determined with a small quantity (reference quantity). The larger the reference quantity,
the higher the counting exactness. High reference must be selected for small parts or
parts with considerably different sizes.
1. Enable function and set reference
Call up menu
 In weighing mode press the MENU button twice
Select piece counting mode
 Press the navigation buttons ( ) repeatedly until
„APL.FUNC" is displayed.
 Confirm with PRINT
 Press the navigation buttons ( ) repeatedly
until „PCS" is displayed.
 Press TARE. The display shows the currently set
memory location.
Enter memory location for reference
 The balance offers the possibility to store five different
piece weights at the same time.
 Press the navigation buttons ( ) repeatedly until the
desired memory location
press TARE.
Display, if no piece weight is stored
Display, if a piece weight is stored
ABS-N_ABJ-NM-BA-e-1614
is displayed, then

57