Working With The Device - DS Produkte HZ-S04 Mode D'emploi

Working With the Device

Control Panel and Display
27
26
25
24
23
22
21 button for setting the preparation time (max. 60 minutes)
22 button for setting the temperature (40 °C to 120 °C)
23 PULSE button for activating the cross-blade attachment at maximum speed
Note: Disabled during the heating process for safety reasons
24 button for activating the scale
25 button for setting the speed level
Note: Disabled at a temperature setting of 120 °C
26 Display PULSE function activated
27 Display of the speed level of the cross-blade attachment
Basic Use of the Device
ATTENTION!
■ Caution: Risk of burns! The metal surface of the mixing bowl also becomes hot
from the heated contents. Only ever touch the mixing bowl by the handle or use
kitchen gloves.
■ Caution: Risk of scalding from hot steam and hot condensation! Be aware that
hot steam will emerge from the mixing bowl lid during cooking. Particular care should
be taken when removing the lid and when using the steaming unit.
■ Risk of damage to the device from overheating! Never place the motor unit on a
soft surface. The ventilation slots on the bottom of the device must not be covered.
Otherwise, the device could be damaged.
■ Risk of damage to the device from falling! Note that when chopping up food the
imbalance which is created in the mixing bowl may cause the whole device to move
in some circumstances. The device should therefore be set up so that it cannot fall
off the work surface.
39
17 Display showing the remaining prep-
17
aration time; when weighing: weight
display; display of (error) messages
18
(see "Troubleshooting")
18 Display of the temperature set in °C
19
START / STOP button for activating
19
the device; switching the heating
function and the cross-blade attach-
ment on and off
20
20 + / – buttons for increasing (+)
and reducing (–) the speed level,
temperature and preparation time
21
once the corresponding button
has been pressed
EN