DS Produkte HZ-S04 Mode D'emploi page 40

EN
■ Do not overload the device! Only chop up hard foodstuffs (e. g. ice cubes) by
pressing the PULSE button with brief pauses.
■ Overheating of the device! Do not allow the device to operate on speed level 2 for
longer than 2 minutes without stopping. Then let the device cool down for a short
while before it is used again.
■ Risk of damage to the stirring attachment! When the stirring attachment is placed
on the device, only use speed level 1.
• For safety reasons, the device can only be switched on if the mixing bowl is
fi tted in the motor unit correctly and the mixing bowl lid or steaming attach-
ment are locked on.
• To save power, the display switches to standby mode when the device is
not used for approx. 4 minutes. "stdy" appears on the display. To switch the
display back on again, press the
1. Place the motor unit on a dry, clean, fl at and non-heatable work surface.
2. Make sure that the suction feet stick properly to the work surface.
3. Insert the mains plug into a properly installed plug socket that is easily accessible.
4. Ensure that the cross-blade attachment is correctly fi xed in place in the mixing bowl.
When using additional accessories, e. g. for stirring or steaming, follow the instruc-
tions provided in "Using Accessories Correctly".
5. Pour any ingredients you want into the mixing bowl. Do not exceed the MAX marking
in the mixing bowl!
6. Secure the mixing bowl lid on the mixing bowl and place the mixing bowl into the
motor unit. If you do not intend to boil milk, cream or pasta or steam food, close the
opening in the lid with the measuring cup that is supplied.
8. Press the
9. Set the preparation time (max. 60 minutes): Press the
setting the minutes and seconds. After pressing the
time using the + and – buttons
NOTE: This step can be skipped if the ingredients are only to be briefl y chopped up
or mixed together and not heated using the PULSE button or ingredients are to be
weighed.
10. To heat or cook the ingredients, press the
set a temperature of between 40 °C and 120 °C. The temperature can be set in incre-
ments of 20.
11. To switch the cross-blade attachment on and off, press the
use the + and – buttons to choose between speed level 1 and speed level 2.
NOTE: The cross-blade attachment is disabled at a temperature setting of 120 °C.
12. Press the
7. Switch on the motor unit by fl ipping the On / Off switch on
the back of the motor unit to the I position. A beep is heard
and the device goes into standby mode. "stdy" appears on
the display.
START / STOP button to activate the device.
START / STOP button. The device starts to operate.
40
START / STOP button.
button, set the preparation
button and use the + and – buttons to
button to switch between
button and