Blade Guard - DS Produkte HZ-S04 Mode D'emploi

5. Check that the cross-blade attachment fi ts securely.
Removing
Follow the steps for inserting in reverse order:
1. Hold the cross-blade attachment at the top end with one hand.
2. Turn the mixing bowl upside down, loosen the wing nut anticlockwise and remove it.
3. Take the cross-blade attachment out of the mixing bowl.

Blade Guard

The blade guard prevents the food being chopped up while it is being stirred.
• The blade guard is placed onto the cross-blade attachment. To do this, hold the end
of the shank of the cross-blade attachment on the bottom of the mixing bowl.
• To remove the blade guard again, twist it back and forth slightly and pull it up and off
at the same time.
35
2. Hold the cross-blade attachment at the top end and place
it in the mixing bowl. Make sure that the cross-blade
attachment rests fully on the bottom of the mixing bowl.
The two locking lugs on the shank must be pushed through
the recesses in the mixing bowl.
3. Hold the cross-blade attachment fi rmly, turn the mixing
bowl upside down and place the wing nut on the end of
the shank. It must be fully recessed. If necessary, twist the
wing nut slightly to do this.
4. Twist the wing nut clockwise as far as it will go.
EN