Assembling The Device; Insert / Remove The Fi Ll Chute - DS Produkte FP7714 Mode D'emploi

Assembling the device

ATTENTION!
❐ Keep children away from the device during operation.
❐ Only use the device if it has been completely and correctly assembled!
❐ During operation, do not reach into the holder for the cutting insert while it is rotating
or into the fi ll chute.
❐ Keep your hair and clothing away from the rotating device parts.
❐ Be careful when handling the cutting inserts, the blades are sharp! When removing or
inserting the holder for the cutting insert, only take hold of the plastic parts and never
touch the blades directly!
❐ Turn off the device and pull the mains plug out of the socket before inserting or remov-
ing the holder for the cutting insert to prevent the device from accidentally activating!
❐ Do not use the device continuously for more than two minutes!
❐ Do not forcefully push food into the fi ll chute.
For best results when cutting and slicing, we recommend cutting foods into
smaller pieces before inserting them in the fi ll chute. This makes it easier to
push the foods down with the plunger.
Always follow the order described below when assembling the device:
1. Inserting the fi ll chute
2. Place the cutting insert in the holder for the cutting insert
3. Place the holder for the cutting insert in the device
Insert / remove the fi ll chute
All manuals and user guides at all-guides.com
1. Hold the fi ll chute tilted slightly to the right so that the arrow
on the fi ll chute is pointing towards the open lock symbol
on the motor unit. Then place it in the motor unit.
2. Turn the fi ll chute to the left until it locks into place and the
arrow on the fi ll chute is pointing towards the closed lock
symbol.
3. To release the fi ll chute, turn the holder to the right until
the arrow on the fi ll chute is pointing towards the open lock
symbol again. Then remove the fi ll chute from the motor
unit.
19