Table des Matières
Publicité
Exposure Time and
Temperature:
Minimum Dry Time:
The following qualified sterilization cycle may also be used for individual instruments, TSGKIT Tapered Short Guided Kit, and
TSGT Tapered Short Guided Tray:
The following qualified sterilization cycle may be used for the INSERT END of ODSecure Cap Insert/Extract Tool (ODSCT):
The following qualified sterilization cycle may be used for the EXTRACT END and BLUE HANDLE of ODSecure Cap
Insert/Extract Tool (ODSCT) and ODSecure Impression Coping Tool (ODSICT):
It is recommended to include a 30-minute cool-down period before removing the product from the sterilization bag or wrap.
Attention! Improper cleaning may lead to inadequate sterilization. Failure to completely dry instruments during autoclaving may
leave moisture and cause discoloration and oxidation. The use of hydrogen peroxide or other oxidizing agents will damage the
surface of the instruments. Periodic testing, cleaning, and calibration of the autoclave equipment is recommended to ensure the
unit remains in proper working order.
Products to be disposed of must be treated and decontaminated as dental surgery waste in compliance with the relevant
regulations.
Reference:
ANSI/AAMI TIR12:2010
Type:
Gravity Steam
15 minutes at 132°C
(270°F)
30 minutes
Exposure Time and Temperature:
Minimum Dry Time:
Exposure Time and Temperature:
Minimum Dry Time:
Exposure Time and Temperature:
Minimum Dry Time:
Sterilization Cycles
ANSI/AAMI TIR12:2010
Prevacuum Steam
4 minutes at 132°C
(270°F)
20 minutes
Sterilization Cycle
Reference:
ANSI/AAMI TIR12:2010
Type:
Gravity Steam
30 minutes at 121°C (250°F)
Sterilization Cycle
Type:
Prevacuum Steam
3 minutes at 135°C (275°F)
Pressure:
Sterilization Cycle
Type:
Prevacuum Steam
20 minutes at 121°C (250°F)
15 minutes
Pressure:
5 of 72
UK HTM 01-01 Part
Prevacuum Steam
3 minutes at 134°C
30 minutes
16 minutes
2.06 bar
1.1 bar
C:2016
(273°F)
20 minutes
Publicité
Table des Matières
