Implements - Grillo FD 2200 TS Manuel D'utilisation

FD2200TS/ Translation of the original instructions

IMPLEMENTS

150 cm ALL PURPOSE FLAIL
This grass shredder (fig. 41) is very useful for cleaning countryside with tall, wild grass. It allows a fine shredding
making collection unnecessary. It comes equipped with "Y" shaped tines as a standard feature, also suitable for
shredding small pruned branches. It can be fitted with grass blades to have a cutting quality equal to that of a
lawnmower, or converted into scarifier by changing the tines with scarifier blades. To make the finish in small
spaces, if the front wheels and their supports are too bulky, they can be removed: you will work then with the grass
shredder resting on the rear roller. It is applied in the same way as the lawnmower. Be careful to fit the universal
joint into the grooved shaft. Regularly check the belts' tension at the side of the grass shredder. The correct spring
length adjustment is 70 mm (fig. 45). If the grass shredder vibrates, check the tines. If the grass is very high and
you notice an excessive power absorption, it is advisable to take off the contra-rotating blade, which is positioned in
the inner part of the grass shredder casing.
ATTENTION! During work, please keep people away; do not work with the implement on gravel or foreign bodies,
which could be thrown away, becoming very dangerous.
160 cm LPM MOWER DECK
The 160 cm LPM cutting deck (fig. 42) is a 3-blade deck, width 1600 mm, the total width with side discharge baffle
is 1920 mm, without baffle is 1700 mm. It has got 3 different functions:
1) Side discharge;
2) Rear discharge;
3) Mulching.
To get from one function to another, it is not necessary to change the blades but only the augers, which are located
in the inner part of the cutting deck (fig. 43).
Choose the most suitable function, considering the places where you have to work and the grass height. We kindly
advise you to use the mulching configuration if you have to cut grass which is 10/12 cm high; the rear configuration
if you do not want that the cutting grass is thrown on streets or paths and the lateral configuration if the grass is not
very high and you have to use it in wide spaces, so that during work you throw the cut grass upon the grass which
has still to be cut. This way the cutting deck cuts the grass several times, grinding it finely (pay attention not to work
when the engine is stressed). Periodically check the belt tension and eventually adjust the spring register (fig. 44,
B). Lubricate the blade shafts (fig. 44, A) with grease every 40 hours. Change the oil in the angle gearbox every 300
hours, using synthetic oil LSX 75W90 (international brand API GLA+GL5; API MT1 and PG2; MIL-L-2150 D).
CABIN
The machine can be equipped with a cabin fitted with a heater as a standard feature (fig. 58). The PREMIUM
version equipped with heating system and air conditioning is available on request. The cabin doors can be held
open thanks to its door stops made on purpose.
FRONT BLADE
The 175 cm front blade (fig. 59) has been especially designed for this machine. This front blade is operated
hydraulically and can be oriented to one side or the other. It is equipped with a rubber end, anti-shock springs and
hydraulic lift. In order to use the front blade it is necessary to apply the hydraulic kit for attachments.
17