Maintenance Summary Table - Grillo FD 2200 TS Manuel D'utilisation

PROCEDURE
check the level
Engine oil
change
check
Air filter
replace
check the level
Hydraulic
oil
replace
Check that the cooler intake
grid is clean
Check that blades are well-
sharpened and well-fixed
Lubricate with grease
● recommended procedure
‫ ٭‬procedure to be carried out if necessary
LUBRICATION POINTS
Find the lubrication points following the scheme below. Grease the rear axle pivots, the pedals, the PTO
transmission belt guide pulley, the pivot connected to 2 points joint of the cutting deck, the grass catcher lifter arms,
the turbine shaft and the PTO tightener (fig. 24) every 50 hours.
FD2200TS/ Translation of the original instructions

MAINTENANCE SUMMARY TABLE

EVERY 8 AFTER EVERY 50
HOURS 20 HOURS
HOURS
●
change)
●
●
●
●
●
13
EVERY EVERY 250
100
HOURS
●
(first
●
(first change after
●
●
EVERY 1000
HOURS HOURS
●
‫٭‬
●
●
500 hours)