After Sales Support; Spare Parts; Rewinding; Bearings - ABB Low Voltage Motors Manuel D'installation, D'exploitation Et De Maintenance

7. After Sales Support

7.1. Spare parts

When ordering spare parts, the motor serial number,
full type designation and product code, as stated on the
rating plate, must be specified.
For more information, please visit our web site
www.abb.com/partsonline.

7.2 Rewinding

Rewinding should always be carried out by qualified
repair shops.
Smoke venting and other special motors should not be
rewound without first contacting ABB.

7.3 Bearings

Special care should be taken with the bearings. These
must be removed using pullers and fitted by heating or
using special tools for the purpose.
Bearing replacement is described in detail in a separate
instruction leaflet available from the ABB Sales Office.

8. Environmental requirements

8.1 Noise levels

Most of ABB's motors have a sound pressure level not
exceeding 82 dB(A) at 50 Hz .
Values for specific machines can be found in the relevant
product catalogues. At 60 Hz sinusoidal supply the values
are approximately 4 dB(A) higher compared to 50 Hz
values in product catalogues.
For sound pressure levels at frequency converter supply,
please contact ABB.
Sound pressure levels for all machines having separate
cooling systems and for series M2F*/M3F*, M2L*/M3L*,
M2R*/M3R*, M2BJ/M3BJ and M2LJ/M3LJ are indicated
in separate additional manuals.
EN-18
ABB/Manual for Low Voltage Motors 01-2009