Guide Bar Maintenance - Ryobi RCS1835 Manuel D'utilisation

Deutsch (Übersetzung der originalen Anleitungen)
sharpening carried out by a service agent who is
equipped with electric sharpener.

GUIDE BAR MAINTENANCE

„
When you have finished working, clean out the
groove and the oil passages, with a scraping hook.
„
Periodically trim the sides of rails using a flat file.
„
If not done in the long run, the featheredges might
break away and damage the bar.
„
If one rail is higher than the other one, it is necessary
to make it even with a flat file and then smooth them
with a file or fine grain abrasive paper.
ACCESSORIES OR REPAIR PARTS
Use only genuine Ryobi accessories or repair parts.
If you need any accessories, check with your dealer.
The main accessories (Chain & Bar) are listed in the
specifications section earlier in this manual.
Model
Carlton Chain N1C-BL-52E SK B
& Carlton Bar 14-10W-MHC UNB Y
RCS1835
& Carlton Bar 14-10W-MHC UNB Y
& Tri-link Bar DCR14B-050-3/8LP-52-B
Carlton Chain N1C-BL-56E SK B &
Carlton Bar 16-10W-N156-MHC
RCS2040
& Tri-link Bar DCR16C-050-Y56LD
English (Original instructions)
Chain & Bar
Oregon Chain 91PJ052X
& Oregon Bar 140SDEA041
Oregon Chain 91PJ052X
Tri-link Chain JL9d-3 x 52
Oregon Chain 91PJ056X
& Oregon Bar 160SDEA041
Tri-link Chain JL9d-3 x 56
DISPOSAL
Power tools and accessories contain large amount of
valuable resources and plastics that can be recycled.
Waste electrical products should not be disposed of
together with household waste. Please recycle where
facilities exist. Check with your local authority or retailer
for recycling advice.
21