Invacare Aquatec Ocean Manuel De Maintenance page 20

Aquatec® Ocean/Ocean Ergo family
1. If the release mechanism A has to be replaced: Screw
on new release mechanism again (release 2 threads or
1.5 - 2 mm distance between the release mechanism
and thread start of piston rod F).
2. Refit bolts D and circlips C to lower fixations G and
if necessary upper fixations H if the whole gas spring
was replaced.
If necessary, push the backrest slightly forwards
to make it easier to insert the bolt.
3. Tighten the nut B on the release mechanism.
1. Prepare the Bowden cable A: Make sure that the cable
end B is correctly positioned in the distributor C.
2. Hang the Bowden wire head G in the release mechanism
E.
The longer end is mounted on the left release
mechanism, the shorter one on the right.
3. Position the thread F of nut D on the release
mechanism and screw it in (make sure that enough
threads are engaged). For this, pull up the cable slightly.
20 1640651-A