19_2.Assembly Of Motorized - Channeled Night Blind (Rif. 26); Anti-Condensation And Demisting; Maintenance And Cleaning - Qualified Operator - Arneg Panama 2 Manuel D'installation

Position the blind fixing 3 on the pin, insert it in the blind support and turn by 90° (C).
Manual blinds width
Recommended preload (with sheet rolled up)
Max. springs load (with sheet completely unrolled)
Remove the stop lever 9, if present, before use

19_2.Assembly of motorized - channeled night blind (Rif. 26)

Insert the 90° stop 8 at the right, rotating it until it locks in the rectangular seat (A)
obtained on the support bracket.
Insert the left channeled blind on the right one with the pin (B).
Insert the 90° stop at the left in the bracket seat, rotating it until it locks in the
rectangular seat (A) obtained on the support bracket.

20.Anti-condensation and demisting

To prevent misting due to condensation, low power electrical resistances are foreseen
on the parts most subjected to this phenomenon, such as: heat insulating glass panels
of the doors, frames and framings, side glass panels, etc.

21.Maintenance and cleaning - qualified operator -

BEFORE ANY MAINTENANCE AND CLEANING OPERATION,
REMOVE VOLTAGE TO THE CABINET VIA THE MAIN SWITCH. TO
PROTECT YOUR HANDS DURING CLEANING OPERATIONS,
ALWAYS USE WORK GLOVES.
DO NOT use hot water on cold glass surfaces; the glass could crack and injure
the operator.
DO NOT use abrasive products and solvents that may alter the surfaces of the
cabinets
DO NOT spray water or detergent directly on the electrical parts of the cabinet.
DO NOT touch the cabinet with wet or damp hands and feet.
DO NOT use the cabinet barefoot
DO NOT use alcohol or similar products to clean the parts in methacrylate
(plexiglas).
DO NOT exert too much strength during the cleaning operations
DO NOT use chlorine-based detergent products such as bleach, that may
corrode the surfaces
avoid contact with or the steams released from acidic products, alkalines, or
ammonia contained in the pavement detergents thst can rust or corrode the
stainless steel.
if you perform internal cleaning with pressurized water jet cleaners (Rif. 9), use
LOW PRESSURE systems (max. 30 bar) with a capacity suitable to remove
any present residue; too high pressures may damage the surfaces.
DO NOT aim the jet directly on the varnished or plastified surfaces.
keep at a minimum distance of 30 cm from the surfaces to be cleaned (Rif. 9).
aiming the jet too near to the dirt can cause damage to the operator and
contaminate parts that are already clean and the environment (Rif. 12).
avoid that fans, overhead lights, electrical wires, and all the electrical devices in
general get wet during the cleaning operations.
The food products can rotten due to microbes and bacteria. Compliance to the hygiene
norms is essential to safeguard the health of the consumer, in addition to compliance to
the cold chain, of which the sales area represents the last ring that can be monitored.
05060117 00 06/05/2011
Spring units load indicative chart
< 1250 mm >1250
20 - 30 25 - 30
50 55
Panama 2
English
35