20_8.Parts Inspection; Dismantling The Unit - Specialised Technician - Arneg Panama 2 Manuel D'installation

Use a soft cloth with a neutral detergent or soap and lukewarm water (max
30°C).
Immediately remove all traces of water or detergent using a dry cloth in order
to prevent marks from forming.
All cleaning operations, including disinfection, rinsing and drying must be
performed carefully, removing all traces of water or detergent to avoid the
proliferation of bacteria that is harmful to health. Parts left to dry with residual
disinfectant detergent may be damaged.
Remove any elements such as sponges, clothes, detergent residue, or water
from the floor that could cause slipping and accidental falls.

20_8.Parts inspection

Once cleaning, disinfection, rinsing, and drying operations have been completed,
carefully check that all the parts are perfectly clean and dry and have not been
damaged or excessively worn. If necessary, replace them.
Attach the elements once perfectly dry and restore the electrical power supply. Once
internal operating temperature has been reached, the unit can be loaded with the
products to be displayed.
If access is needed to the fans or the components under the base tub
Rif. 28:
1 - use adequate pliers
2 - hold the cap of the hold of the base tray
3 - lift the tray
at the end of the operation replace the tray using the same procedure

21.Dismantling the unit - specialised technician -

The unit must be disposed of in accordance with your country's waste management
legislation and in respect of our environment. This product is considered by current
legislation as hazardous waste. It must therefore be collected separately and cannot
be treated as household waste nor sent to a landfill. Before disposing of the unit, the
coolant must be collected and the lubricant oil removed. This product consists of 75%
recyclable materials. Materials used in construction:
- Enamelled steel:
- Copper, Aluminium:
- Galvanised sheet metal:
- Polyurethane foam (H
- Tempered glass:
- Wood:
- PVC
- Polystyrene:
- Polycarbonate
The user is responsible for delivering the product for disposal to the collection
centre specified by the local authorities or manufacturer for the recovery and
recycling of materials.
All these operations, as for transport and waste processing, should be
performed by authorised, specialised personnel only.
05060133 00 23/07/2012
uprights, shelves, feet
refrigeration circuit, electrical system and light fixture
lower panels, enamelled panels, base structure,
shelves, trays
O): heat insulation
2
glass sides
side frames foamed tank
Bumpers and handrail
Heat formed shoulders
fluorescent lamp guard
Panama 2 H125-150
English
37