Installation And Environmental Conditions (Rif. 3) - Specialized Technician; Combining Cabinets (Rif. 21) - Arneg Panama 2 Manuel D'installation

Proceed with a first cleaning using neutral products, dry with a soft cloth, do not use
abrasive substances or metallic sponges;
To correctly dispose of the packing, bear in mind that it is made up of: Woood -
Polystyrene - Polythene - PVC - Cardboard.
DO NOT use alcohol to clean the parts in methacrylate (plexiglas).
During the unpacking operations, do not leave elements of the packing
unattended such as nails, wood, gripper rods, nylon, etc. and tools used for the
operation such as pliers, scissors, pincers, in the work area, which could cause
wounds and injuries.
These objects must be removed with appropriate means and brought to their
respective collection places.
10.Installation and environmental conditions (Rif. 3) - specialized
technician -
Any modification to the installation described herein must be authorized by
ARNEG Spa
To ensure that the technicians appointed to installation may operate safely, we
recommend to use the instruments and protection clothing required by the safety
norms or by the laws in force in the country of installation. At any rate, always use
adequate equipment and clothing, such as: anti-injury boots, protection gloves,
spirit level.
The cabinet has been designed to exclusively operate in indoor environments.
For the installation, adhere to the following:
carefully examine the installation area, eliminating any danger to the operator;
DO NOT position the cabinet:
in environments where explosive gaseous substances are present;
in open air and therefore subjected to atmospheric agents;
near heat sources (direct sunlight, heating systems, incadescence lamps, etc.)
near air currents (near doors, windows, air-conditioning systems, etc.) that exceed a
speed of 0.2 m/sec.
Remove the supports in wood at the base (used for transport) and assemble the
adjustable feet (Rif. 4) positioning them so as to place the cabinet horizontally, aiding
yourself of a level (Rif. 5) to check proper alignment .
Before connecting the cabinet to the electrical line, make sure that the rating plate data
matches the characteristics of the electrical system to which the cabinet must be
attached.
For a correct operation of the cabinet, the room temperature and relative humidity must
not exceed the limits relative to climatic class 3 (+25°C; R.U. 60%) established by the
norms EN-ISO 23953 - 2 with which the counter has been tested.
If the cabinet is displaced, re-check its levelling; an incorrect levelling
compromises operation of the cabinet.
The cabinet must be leveled both at the front and at the back.
Install a maximum of 3 cabinets in channel on the same electrical and
refrigerant power supply line (1 master + 2 slave)

11.Combining cabinets (Rif. 21)

To combine two or more cabinets in channel, proceed as follows:
Disassemble the shoulders (if present).
Position the cabinets side by side
Remove the backrests to have access to the holes of the risers
05060117 00 06/05/2011
Panama 2
English
31