20_4.Cleaning The "Honeycomb" (Rif. 8); 20_5.Cleaning Glass Parts; 20_6.Cleaning Stainless Steel Parts; 20_7.Cleaning Aluminium Parts - Arneg Panama 2 Manuel D'installation

Panama 2 H125-150
English
Before beginning to clean the inside of the unit, it is necessary to:
Turn off the power supply
Completely remove all merchandise inside.
Remove all the removable parts, such as display plates, grills, etc.
Wash with lukewarm water (max 30°C).
Disinfect using a detergent with an antibacterial component.
Carefully clean the tank, drip, and water discharge protection grill, eliminating all
foreign bodies that may have fallen into the suction grill, lifting the fan plate if
necessary.
Carefully dry using a soft cloth.
If any ice has formed, contact a qualified refrigeration technician for assistance.

20_4.Cleaning the "honeycomb" (Rif. 8)

The honeycomb must be cleaned every 6-8 months, based on sales conditions.
It can be cleaned using a vacuum cleaner or can be removed and washed using
soap and water.
It must be completely dry before being re-attached.
The honeycomb must be attached at the same angle.

20_5.Cleaning glass parts

DO NOT use hot water on cold glass surfaces, as the glass could shatter and
injure the operator.
DO NOT use rough or abrasive materials or metal scrapers that could scratch
the glass surfaces
DO NOT use dirty cloths
Use a soft cloth with a neutral detergent or soap and lukewarm water (max
30°C).
Immediately remove all traces of water and detergent with a dry cloth in order
to prevent marks from forming and to prevent liquid from reaching the
gaskets, frame, or the glass door hinges.

20_6.Cleaning stainless steel parts

Certain situations may lead to the build-up of rust on steel surfaces:
steel implements left on surfaces that are damp, lime scaled, not fully rinsed after
using chlorine- or ammonia-based detergents, encrusted with pieces of food, salt/
saline solutions, or dry residue from evaporated liquids.
Recent marks and rust:
clean with shampoo or neutral detergents using a sponge or cloth. When done,
remove any detergent residue, rinse well, and carefully dry the surfaces.
Old marks and rust:
use chemical substances for stainless steel that contain 25% nitric acid, or similar
substances.
Stubborn marks and rust:
sand or shine using a stainless steel brush. When complete, wash using
detergents and dry carefully. This may produce surface scratches due to abrasive
cleaning.

20_7.Cleaning aluminium parts

DO NOT use acid or alkaline detergents (e.g. bleach) which could corrode the
surfaces
DO NOT use rough or abrasive materials or metal scrapers that could scratch
the aluminium surfaces
DO NOT use steam cleaning equipment
DO NOT use dirty cloths
36 05060133 00 23/07/2012