Console Reset; Advisory Messages - Mackie Designs RCF BM 3616 Instructions D'installation Et D'emploi

will be made when all the zones selected are available. The LEDs of the numerical keys corresponding to the available zones (or groups
of zones) are lit in continuous mode, and the LEDs of the numerical keys corresponding to the engaged zones (or groups of zones) flash.
c.
Indicates that one or more zones (or groups of zones) of the current selection cannot be used because of a fault on a device of the sy-
stem, which is also indicated by the "REMOTE FAULT" LED. The message cannot be played.
d.
The message is preceded by the "PTT" LED (ref. 19 – Fig. 1, page 132) which lights up to indicate that automatic playback of the mes-
sage is in progress in all the zones (or groups of zones) previously selected (numerical key LEDs lit). In this condition, the "PLAY" LED
(ref. 17 – Fig. 1, page 132) flashes. At the end of the playback, all the zones and/or groups of zones selected are disconnected from the
console, and all the selections made are reset. The LEDs corresponding to the zone/group selection keys go off, along with the "ENTER",
"CLEAR", "PLAY" and "PTT" LEDs, and the message preceding the selection returns to the display (e.g. "COMMUNICATION ON").
IMPORTANT NOTES
• Due to special events (e.g. an emergency situation), the status of the zones may change. Free zones already connected to the console
could be engaged by other users having absolute priority ("override" capacity).
• The messages on the display and the way the LEDs are lit indicate the status of the system, and can therefore vary at any time (e.g. chan-
ge in status of the zones from free to engaged or vice versa).
4) To cancel the request made and interrupt the playback function, press "CLEAR". The LEDs corresponding to the zone/group selection
keys go off, along with the "ENTER", "CLEAR", "PLAY" and "PTT" LEDs, and the message preceding the selection returns to the display
(e.g. "COMMUNICATION ON").
IMPORTANT NOTE
• By pressing "CLEAR", you can interrupt message playback immediately, even if it is already in progress.

CONSOLE RESET

This procedure makes it possible to reset the microprocessor incorporated in the console without having to interrupt the power supply. Re-
setting should only be carried out when absolutely necessary; i.e. when malfunctions occur, as it may interrupt the communication with the
CP 3100 control unit.
IMPORTANT NOTES
• The console reset procedure cannot be carried out if the console is locked (see the section "CONSOLE LOCKING").
• The console reset procedure cannot be carried out if the console is in alarm status (see the section "ALARM FUNCTION CONTROL").
1) Press "F1", "F2", and "F3" together and keep them pressed.
2) Press "CLEAR" and "ENTER" together, then quickly release all the keys pressed. The console is automatically reset, and the following
messages appear on the display in sequence.

ADVISORY MESSAGES

The messages shown below appear on the console display to alert the user to a problem.
a.
This message is shown in the following cases:
– "ENTER" has been pressed without first having pressed the function key configured for relay control (e.g. "F1") or a zone/group selec-
tion key (e.g. "4");
– the "PTT" key has been pressed without first having selected the zones/groups of zones in which the microphone announcement is to
be transmitted.
FAULT ZONES !
PLAY STARTED
RESTARTING !
!
COMMUNICATION ON
NOTHING SELECTED
47