Electric Motor Installation - Horizon Hobby HANGAR 9 OV-10 Bronco 30cc Manuel D'utilisation

ELECTRIC MOTOR INSTALLATION

 Skip this section when installing gas engines.
106. Attach the mount to the motor using the hardware included
with the motor. Use a drop of threadlock on each screw to
prevent them from vibrating loose.
107. Measure the length of the motor and record it.
 The required length of the motor and motor mount
5
is 6 / inches (169mm). Position the firewall in
8
the motor box so the length of the box, plus the
length of the motor, total this dimension.
108. Mark the position of the fi rewall on the motor box so it can
be positioned after the epoxy has been applied. Remove the
bottom support from the motor box before proceeding.
109. Apply 30-minute epoxy to the areas of the motor box where
the fi rewall will be positioned. Slide the fi rewall in position
and allow the epoxy to cure before proceeding
EN
110. Use 30-minute epoxy to glue the triangle stock inside the
motor box against the fi rewall. The triangle stock will require
trimming to fi t tightly in the corners. Allow the epoxy to fully
cure before proceeding.
111. Use 30-minute epoxy to glue the bottom support in position.
Make sure to glue triangle stock under the brace at the
fi rewall and the mount that fi ts against the fuselage.
112. Place the mounting template on the fi rewall. Use low-tack
6 5 / inches (169mm)
8
tape to hold the template in position. Use a drill and 7/32-inch
(5.5mm) drill bit to drill the four holes in the fi rewall to attach
the motor box.
113. Slide an M5 lock washer, then an M5 washer on the M5 x 25
socket head screw. Prepare all four screws.
114. Attach the motor box to the fi rewall using the screws from the
previous step.
20