Horizon Hobby HANGAR 9 OV-10 Bronco 30cc Manuel D'utilisation page 11

40. Use a pin vise and 1/16-inch (1.5mm) drill bit to drill the four
holes for the servo mounting screws. Make sure to harden
the screw holes.
41. Assemble the linkage for the aileron using two rod ends and
the 4 1 / inch (114mm) threaded rod. Snap an aluminum ball
2
into each of the rod ends. Thread each ball end a minimum
of 12 turns on the link. Adjust the length so the overall length
1
measures 5 / inches (140mm).
2
42. When attaching the linkage to the servo arm, use the hole in
the arm that is 1-inch (25mm) from the center of the arm.
43. Attach the link to the servo arm using an M3 x 12 button head
screw, M3 washer and M3 Lock nut. Use a 2mm hex wrench
and 5.5mm nut driver.
 The washer must be placed on the outside of the ball link,
opposite the servo arm. Omitting this could cause the ball
to pop out of the plastic ball link, causing loss of control.
44. Place the servo in the wing, guiding the linkage through the
opening near the aileron hinge line. Secure the servo using
the hardware included with the servo.
OV-10 Bronco 30cc
45. Secure a 12-inch (300mm) servo extension to the aileron
46. Retrieve the servo lead from the wing panel.
inches (140mm)
5 1 /
2
47. Install the aileron control horn using the same technique as
1 inch
(25mm)
 Do not over-tighten this screw as it
 Repeat this section to install the remaining
11
servo lead. Route the servo lead and extension through the
tube inside the wing. The lead will exit in the opening for the
fl ap servo before continuing through the wing panel.
the elevator control horn. Allow the epoxy to fully cure before
proceeding. With the servo connected to the radio system,
center the aileron servo. Attach the linkage to the control horn
using an M3 x 12 button head screw and M3 lock nut. Adjust
the linkage to center the aileron. Once the linkage has been
adjusted, tighten the hardware using an M3 hex wrench and
5.5mm nut driver.
may result in excess friction.
aileron and aileron servo.
EN